Changzhou kai industrial drying equipment co., LTD. The vibration fluidized bed dryer common troubleshooting: 1. The fault phenomenon: drying machine is not running the compressor line disconnect fuse thermal relay action of high voltage switch action compressor locked-rotor lines or loose
2. The fault phenomenon: drying machine in a short period of time after starting the stop environment temperature is too high the condenser blocked? Compressor overload too much lack of refrigerant low voltage is too low the volume compressor jammed
3. The fault phenomenon: compressor don't start the wiring is not correct voltage too low start capacitor damage relay or contactor is not closed start winding open phase
4. The fault phenomenon: compressor start-stop repeatedly because of overload protection action on low voltage three-phase unbalance overload protector or design connect with other electrical equipment? Work overload protector failure capacitors is too small? High exhaust pressure between winding short-circuit thermal relay contact with tape
5. The fault phenomenon: drying equipment relay voltage too high or too low to run capacitor burn out is not correct rev. Stop (see 2 and 3) relay repeatedly specifications of installation is not correct
News source: http://www.kgdry.com/Cn_Products.html
